V-Bar Mounting

Edmonton Radio Control Helicopter Association > General Category > Helo Help Me > V-Bar Mounting

Pages: [1]

« previous next »

Author

Topic: V-Bar Mounting (Read 6531 times)

Freeskiken

ErchaExecutive
Hero Member

Offline

Posts: 267

V-Bar Mounting

« on: January 08, 2011, 04:25:38 AM »

Hi, I want to mount the V-Bar sensor. MrMel's video says to use a piece of lego to align the sensor with the frame. If I do this the sensor will not be in the middle between the frames. It will be to one side a little more than the other side. Does this matter ? I am mounting it on my TRex 600 below the receiver mounting plate on the bottom plate near the back with the wire facing forward. Thanks for the help. Ken


« Last Edit: January 08, 2011, 04:31:27 AM by Freeskiken »	Logged

Burtondude

ErchaMember
Full Member

Offline

Posts: 42

Re: V-Bar Mounting

« Reply #1 on: January 08, 2011, 05:13:23 PM »

I did not use a piece of Lego. I mounted it where it fit, it is off center but works perfectly.


	Logged

OICU812

Sr. Member

Offline

Posts: 60

Re: V-Bar Mounting

« Reply #2 on: January 08, 2011, 08:22:44 PM »

As long as it is square to the axis, this is what matters is all. Left right makes no diff, just square.


	Logged

Kevlar11

ErchaMember
Hero Member

Offline

Posts: 114

Re: V-Bar Mounting

« Reply #3 on: January 10, 2011, 04:21:46 PM »

Rea'l, my 9 year old calls my logo 600 a " lego 600 " Ken if you need a chunk of Lego I'm sure he will lend you one LOL

KD


	Logged

Freeskiken

ErchaExecutive
Hero Member

Offline

Posts: 267

Re: V-Bar Mounting

« Reply #4 on: January 11, 2011, 02:40:41 AM »

Thanks for the help. When I mounted it I lined it up square to the back with Lego. Hope this works. Ken


	Logged

Pages: [1]

« previous next »