|
: V-Bar Mounting : Freeskiken January 08, 2011, 04:25:38 AM Hi, I want to mount the V-Bar sensor. MrMel's video says to use a piece of lego to align the sensor with the frame. If I do this the sensor will not be in the middle between the frames. It will be to one side a little more than the other side. Does this matter ? I am mounting it on my TRex 600 below the receiver mounting plate on the bottom plate near the back with the wire facing forward. Thanks for the help. Ken
: Re: V-Bar Mounting : Burtondude January 08, 2011, 05:13:23 PM I did not use a piece of Lego. I mounted it where it fit, it is off center but works perfectly.
: Re: V-Bar Mounting : OICU812 January 08, 2011, 08:22:44 PM As long as it is square to the axis, this is what matters is all. Left right makes no diff, just square. :)
: Re: V-Bar Mounting : Kevlar11 January 10, 2011, 04:21:46 PM Rea'l, my 9 year old calls my logo 600 a " lego 600 " Ken if you need a chunk of Lego I'm sure he will lend you one LOL
KD : Re: V-Bar Mounting : Freeskiken January 11, 2011, 02:40:41 AM Thanks for the help. When I mounted it I lined it up square to the back with Lego. Hope this works. Ken
|