Freeskiken
ErchaExecutive
Hero Member
Offline
Posts: 267
|
 |
« on: August 14, 2012, 08:38:20 PM » |
|
Hi, I haven't programed a DX7SE very often since I use Futaba normally. In the settings for the 130X it says GYRO SENS - INH. I can't seem to set it to INH. So I set the Gyro Sens to 0:0% and 1:0% will this be the same as INH ?
The other thing was SWASH MIX - INH . It says in the DX7SE manual that Swash Mix is only displayed when CCPM is activated. Since you pick swash type 1 Servo Normal. It does not show up in the DX7SE menu ?
Your help would be appreciated. Thanks Ken
|