Edmonton Radio Control Helicopter Association

General Category => Helo Help Me => Topic started by: Freeskiken on August 14, 2012, 08:38:20 PM



Title: DX7SE Programing Blade 130X Help
Post by: Freeskiken on August 14, 2012, 08:38:20 PM
Hi, I haven't programed a DX7SE very often since I use Futaba normally. In the settings for the 130X it says GYRO SENS - INH. I can't seem to set it to INH. So I set the Gyro Sens to 0:0% and 1:0% will this be the same as INH ?

The other thing was SWASH MIX - INH . It says in the DX7SE manual that Swash Mix is only displayed when CCPM is activated. Since you pick swash type 1 Servo Normal. It does not show up in the DX7SE menu ?

Your help would be appreciated. Thanks Ken


Title: Re: DX7SE Programing Blade 130X Help
Post by: Kevlar11 on August 15, 2012, 08:12:34 AM
Ken I can come by and give you a hand I'm working in mill woods today what time is good I'm done at 4

Kevin


Title: Re: DX7SE Programing Blade 130X Help
Post by: Freeskiken on August 16, 2012, 05:39:37 AM
The gyro Sens has to be set to 0:50% and 1:50% . Same as off. Flew 2 flights and it flies great.  Thanks Kevin